When the IMC01 reports the following Error Code, the banknote that caused the error will not be counted in the total, and you need to take the wrong one away.
Notice: When the IMC01 reports the Chain Error, the counting result will be inaccurate, please fine-tune the screw to adjust the feeding gap according to section 2.6.
Code |
Error Message |
Handling Method (Recommendation) |
E1 |
UV Fault |
Remove the banknote, clean the UV sensor |
E2 |
Double Notes |
If the errors occur frequently, adjust the screw toward the anti-clockwise to decrease the feeding gap. |
E3/E8 |
Chain Notes |
|
E4 |
Half Note |
Remove the banknote |
E10 |
Image Error |
Fine-tune the screw to adjust the feeding gap according to video:http://u.pc.cd/NHOctalK, And perform the CIS calibration |
E11/E12 |
Denomination Error |
Remove the banknote, clean the CIS sensor; Perform the CIS sensor calibration; Collect the data of the banknote. |
E13 |
Face Recognition Error |
|
E14 |
Size Recognition Error |
|
E15 |
Orientation Recognition Error |
|
E20 |
MT Error |
Remove the banknote, clean or replace the MG sensors |
E21 |
MG1 Error |
|
E22 |
MG2 Error |
|
E23 |
MG3 Error |
|
E24 |
MG4 error |
|
E30-E38 |
IR ERROR |
1. Install the banknote guiders 2.Check bills 3.Remove the banknote, fine-tune the screw to adjust the feeding gap according to video:http://u.pc.cd/NHOctalK 4.Clean the CIS sensor and perform the CIS calibration;
|
|
Motor Error |
Please check if there is any foreign matter stuck inside IMC01. Follow the instructions in Maintenance Manual |
|
Stacker Error |
Please refer to the section to clean the stacker sensor: |
In the process of using the IMC01, the IMC01 may show an abnormal state and display the error codes on the screen. The description of the error codes and the related handling method is shown in table 2-1.
Dear MUNBYN Customer, contact us for further assistance,
E-mail: support@munbyn.com
Whatsapp: +8618144898200
Comments
0 comments
Please sign in to leave a comment.