MUNBYN Leo
- Total activity 1725
- Last activity
- Member since
- Following 0 users
- Followed by 3 users
- Votes 7
- Subscriptions 863
Articles
Recent activity by MUNBYN Leo-
What should I do if my printer gets stuck on the "Printing" pop-up when printing via the Munbyn Print app?
Please try the following steps in order: 1. Restart your printer: Power off the printer, wait at least 5 seconds, then turn it back on. Let it sit for 1–2 minutes for Bluetooth initialization. Then...
-
What should I do if my printer gets stuck on the "Printing" pop-up when printing via the Munbyn Print app?
Please try the following steps in order: 1. Restart your printer: Power off the printer, wait at least 5 seconds, then turn it back on. Let it sit for 1–2 minutes for Bluetooth initialization. Then...
-
How to Clean Pogo-Pin Contacts When Printing Is Only Black Blocks or Lines or Any Other Abnormal Printouts?
If your RW405B prints solid black blocks, black lines, or severely distorted images, the electrical contacts between the printer and the print-head assembly may be dirty. Cleaning the pogo-pin cont...
-
How do I enable the IMC27 to automatically accumulate the banknote counting results?
Press the "ADD" button to activate Add Mode— the ADD indicator light will illuminate.In Add Mode, the counter will keep accumulate the total number of bills when multiple stacks bills are counted. ...
-
How do you calculate the total amount of banknotes?
Value Mode (Manually preset the denomination)Press the "VALUE" button to activate Value Mode— the VALUE indicator light will illuminate.Repeatedly press the "VALUE" button to cycle through preset v...
-
How to disable the sound of beeping when triggering the error
Step 1: Long press ‘VALUE’ and ‘BATCH’ button at the same time to enter setting mode. Step 2: Click the ‘BATCH’ button for multiple times to switch the parameter to ‘C32’.Step 3: Click the ‘CUR’ bu...
-
How to disable the sound of beeping when pressing the keys
Step 1: Long press ‘VALUE’ and ‘BATCH’ button at the same time to enter setting mode. Step 2: Click the ‘BATCH’ button for multiple times to switch the parameter to ‘C30’.Step 3: Click the ‘CUR’ bu...
-
False Alarm happens frequently
Clean the sensorIf the problem persists, please contact us using the contact information below.Email: support@munbyn.comWhatsapp: +8618144898200
-
Counting result is not accurate
Solution 1: Click here to see how to adjust the feeding gapSolution 2: Clean the counting sensorIf the problem persists, please contact us using the contact information below.Email: support@munbyn....
-
The motor can not start or stop normally
Solution 1: Clean the feeding sensor in the hopperSolution 2: Check and connect the electric circuit of feeding sensor